Well since the grill panel is off the car and the radiator is out, additionally as I am well over sanding car panels, decide to clean up the engine bay a little bit, well the lower engine bay. It has long needed something done it to as the job was never finished when the chassis rails were replaced and it the lower engine bay has been basically primer and surface rust since then.
On the plus side for not having done any work in the engine bay, when the bumper mounts needed replacing recently there was no need to worry about making a mess as it wasn't in a good tidy condition anyway. The downside though its that it looked very rough in there.
 |
| When the bumper was replaced the engine bay was still a mess to see. |
More sanding and rust converter and priming and painting. Tidied the wiring up, by wrapping the loose wires and tied them to the main loom. It is no show winner and was never supposed to be such, but it sure is much neater in there.
No comments:
Post a Comment